Terminate Cloning

Use the following procedures to stop the cloning process before it is complete.

To terminate cloning

• When using the service, from the Client Console, use the Abort command.
• When using dbutility, use the QUIT NOW command.

To terminate cloning during the fixup phase

• When using the service, from the Client Console, use the Stop command. During the data extraction phase, if you issue a QUIT command (or you send a SIGTERM signal when using UNIX), the DATABridge Client stops only when the fixup phase begins.
• When using dbutility, use the QUIT command (or the SIGTERM (15) signal on UNIX).

  Note: If you issue a QUIT command or send a SIGTERM signal to the program during the data extraction phase, the DATABridge Client stops only when the fixup phase begins.

When you terminate the Client during the fixup phase or during updates, the process command restarts from the last commit point. If you terminate the Client during the data extraction phase, only the data sets that have successfully completed the data extraction phase (ds_mode=1) are recoverable. You can resume the process by running another process command.

If all of these commands fail to terminate the client, press Ctrl+C.