Run the Server Accessory

Follow these steps to edit the Server Accessory parameter file before you run Server Accessory.

To run the Server Accessory

  1. Use CANDE or another editor to save the Server Accessory parameter file DATA/SERVER/SAMPLE/CONTROL as DATA/SERVER/CONTROL.
  2. Edit the Server Accessory parameter file (DATA/SERVER/CONTROL) and save the file when you're finished. See Server Accessory Parameter File.
  3. Make sure that the DMSII database security attributes are set to give the Engine read access to the DMSII database and DMSII DESCRIPTION, CONTROL, and audit files. See the DATABridge Installation Guide for information about configuring guardfiles.
  4. From the usercode that contains the Server Accessory files, start the Server Accessory as follows:

    START WFL/DATABRIDGE/SERVER

    After the Server Accessory starts, it will sit idle in the mix until it receives a request from a DATABridge Client. If the Server Accessory fails to start, see Troubleshooting Server Accessory Usercodes.

  5. To check the status of a Server Accessory client process or to take Server Accessory out of the mix, see Server Accessory Commands.