Debug Command List

Select Debug Command List on the Debug menu or click the Debug button on the Operation tab to open the Command Debug dialog box. This dialog box is used for debugging an operation or command list (for example, a move cursor, login or logout command list) created in the Design Tool.

Note: Click the Apply button before debugging a command.

To test and debug a command list:

1. Select the operation or command list to test from the Name box and click Run. The Design Tool runs through each command listed and then reports the operation's success or failure in the Status box.
2. Click Step to execute the highlighted command, or click Skip to pass over it.
   
3. To stop execution of the command list as it is running, click Stop.