From the Advanced page, you can configure port settings for your host.
Remote Port: Type the host port to use. For any hosts or applications not listed below, contact your host administrator for the correct value to use.
This host or application Typically
uses this port
Unisys ClearPath NX, ClearPath LX, and A Series hosts or other hosts that use Telnet communication protocols 23 Applications that use the File Transfer Protocol (FTP) 21 Electronic mail (SMTP) 25 Applications that provide an interface to query programs at several network sites (FINGER) 79 Applications that use the Network News Transfer Protocol (NNTP) 119
Lingering (Sec): Type the number of seconds to wait for an acknowledgment from the host after the session is closed. The connection will close even if an acknowledgment is not received within this amount of time.
If your network experiences a great deal of traffic, or if the clients are part of a wide area network (WAN), setting this value between 1 and 4 should allow ample opportunity for the host to respond. If you type 0, the connection closes without waiting for an acknowledgment from the host. This makes the socket available more quickly, but for some hosts (such as Unisys A Series hosts), this generates network errors.
Alternate IP Address: If desired, type the IP address or domain name for an alternate host.
If a connection to the host cannot be established using the IP address or domain name specified on the General page (due to a connection time-out or an unsuccessful connection attempt), the IP address or domain name you specify here is used.
|Configuring a T27 Host Connection|
|Creating a T27 Configuration|
|Presentation Designer Help Links|